How to Install Wire Shelving

Cable shelving provides a fast and effortless way to a cluttered cupboard. Basic cable shelving is connected to walls with support brackets. For entire wall lengths, we recommend ?nding a system which also comes with return wall mounts (frequently called “side wall brackets”) and encourages clips. Both drywall shelf ring and clips piercing clips are available at home centres. Support mounts put at stud locations further stabilize the device.

A marginally advanced style of cable shelving that’s increasing in popularity is track-mounted. It is available in more styles than conventional white vinyl-coated wire shelving. This type of wire shelving consists of a horizontal rail track that affirms vertical rails, or the vertical can be directly fastened to the wall. Shelf brackets then snap to the verticals and shelves are set in addition to the plate supports. These programs are workable closet organizers but cannot keep as much weight as wood or melamine systems. Wiredex offers tailor made retail shelving solutions of all types. The span should be kept to 36? or less and have adequate support–by hitting studs at which you can and using toggle bolts each 16?.

Tools & Materials

Measuring tape
Level
Hacksaw
Shelving system and hardware
Drill

MEASURE WALLS AND MARK FOR SHELVING PLACEMENT
Measure the period of the back wall and the side walls. Measure up from the floor to the desired height for the top shelf and draw a level line on every side wall. Note: The average minimum height above ground is 48?. Mark all stud locations along the rear wall and side walls.

CUT WIRE SHELVING
Cut cable shelving to ? t between walls, using a hacksaw. For shelving spans greater than eight ft., cut multiple shelves and join them with the producer’s connectors (which are often sold in home centres that take cable shelving).

ATTACH SIDE-WALL SUPPORTS
On a side wall, then decide placement of the side-wall service according to manufacturer instructions. If directions are not provided from the producer, ?t the aid in place on the wire shelf and then, while holding the shelf in place along the level lines, mark the screw hole placements for the side-wall supports on the side walls.

Predrill holes in the marked side-wall service places. Hold a support set up and add a toggle bolt through the support to the wall. Repeat with another side-wall support. Note: If you can hit a stud, a toggle bolt is not necessary; rather, use a standard 1 1 / 2 ” drywall screw.

Set the wire shelving to the side-wall supports. Just lower the shelving into place until it clicks into the supports. Have a helper hold the shelf so that the two side-wall brackets are not bearing the load of this shelf. Check for the level.

MARK WALL FOR SUPPORT CLIPS
With wire shelving still ?t into the side-wall supports, make a mark roughly every 6? across the wall. Space the marks evenly between studs.

Remove the wire shelving. Hold a clip at each mark, according to manufacturer instructions, and indicate the pin-hole place. Note: There is an offset in the amount line on the wall that must be taken into account.

Predrill holes in the support clip marks on the back wall to the pin-hole positioning. Add the wall clips by pressing on the producer pin throughout the clip and into the wall. Lower wire shelving into the side-wall supports until they snap into place. Gently press the back of the shelving into the support clips.

Where possible, align service mounts at stud locations. Mark screw holes on the wall. Ascertain where the other mounts will proceed on the wall for a uniform appearance. Space brackets approximately every 16? apart across the back wall.
For brackets that aren’t secured to studs, use sticks.

Fasten the other end of the brackets to the cable shelving by the manufacturer directions.

Leave a Reply

Your email address will not be published.